Bellinzoni Ultra Stripper

Instructions

Dilute 5 – 10% of product in water (50 - 100 ml in 1 litre); apply with a mop/brush or for big areas by floor polisher equipped with medium cleaning pad or carbon brush.  Repeat the operation if necessary. Rinse the floor thoroughly with clean water to avoid the dirt drying in the joints and gaps and if possible, remove the water with the vacuum.

For application on vertical surfaces (indoor or outdoor wall claddings, columns, statues etc) use a brush with GEL STRIPPER. Spread the product and then rub hard with the pad or brush over the same surface. Rinse well.

For vertical application and mainly building façades it is possible to use a brush and then rinse very well using a pressure washer or put the mixture directly into the tank of the machine.

Application tools

• Single Disc Machine
• Mop
• Scrubbing brush
• Brush
• Pressure washer

Suggestion for use and recommendations:

Dilute the product in water in dependence of the dirt to be removed. We suggest following dilution:

• Clean spot of pollution, grease etc… dilute 100 ml of product in 1 litre of warm water
• Premix the product in the floor scrubbing machine tank.
• In case of stubborn dirt, increase the product concentration depending on the requirement.
• Recommend using ULTRA STRIPPER for deep cleaning of the floors prior crystallization or to clean places with very stubborn dirt such as car workshop and showrooms, parking lots, industrial floors etc.
• We recommend using lukewarm water.
• The product is alkaline based therefore we recommend rinsing all tools used for the job, specially the vacuum unit or single disc machine
• Carefully Read recommendations printed on label and perform a preliminary test on a small area before actual use.
• For specific spots on vertical surfaces it is suggested to use our GEL STRIPPER

Application surfaces

• Marble
• Travertine
• Granite
• Ceramic
• Porcelain

Coverage

To wash stone floors, it is possible to treat 200/250 sqm with 1 litre of product. Coverage of product

depends on the intensity of the dirt that needs to be removed.